Stop Address Tools

For more, see GeoCode The proccess of assigning x, y coordinates to data that is not intrinsically geospatially referenced.

To activate: Layer Tools / PW Stops tab

Use the Stop Address tool to reconcile spelling differences and/or address range problems between the GeoSyncŪ roads layer and PW Route Stop addresses.

To Use:

1. Activate Stop Address tool.

2. Check the XY = 0 box.

3. Check the Rides>0 box.

4. Select the Load button.

5. Values in the top box are road names from the roads layer; Values in the lower list box are non-matching stop addresses to be corrected.

6. Select the road name out of the roads list (i.e. Walnut Ave).

7. Select the road name to be changed, from the lower list box (i.e. Walnut Lane).

8. With both lines highlighted, select the update button. This will change the street name in the stop address to match the name in the roads layer. Be careful to select the correct road name.

9. Select GeoCode Selection to refresh the list to exclude the corrections made, or correct several errors and then GeoCode All to reflect changes.